Jan 312018
 
  1. After checking the oil level (see procedure 2), make a note of how much is needed for topping up.
  2. Make a visual check on the pipes, electric pump, tank, hydraulic unit, engagement/selection actuator, clutch stop pin (removing the casing that covers it) while making 50 gear shifts from 1st to 5th/R and from 5th/R to 1st ( at a frequency of 1 gear change every 3-4 s).
  3. If leaks are found, replace/repair the parts involved, top up the oil and start again from step 1.
  4. If there are no leaks:
    • if the quantity of oil for the first topping up is > 200 cc -> replace the hydraulic unit,
    •  if the quantity of oil for the first topping up is < 200 cc -> repeat step 2 watching carefully for leaks from the clutch stop pin (removing the casing that covers it and cleaning the parts involved), if everything is ok continue with the next step of the diagnostics table.
 Posted by at 7:03 pm